Serviços Personalizados
Artigo
Indicadores
Links relacionados
-
Citado por Google
-
Similares em Google
Compartilhar
Journal of the Southern African Institute of Mining and Metallurgy
versão On-line ISSN 2411-9717
versão impressa ISSN 2225-6253
J. S. Afr. Inst. Min. Metall. vol.109 no.1 Johannesburg Jan. 2009
TRANSACTION PAPER
Nonlinear rock behaviour and its implications for deeper level platinum mining
B.P. WatsonI; J.S. KuijpersI; G. HenryI; C.E. PalmerI; J.A. RyderII
ICSIR, Johannesburg, Gauteng, South Africa
IIRyder Marketing and Research, Johannesburg, Gauteng, South Africa
SYNOPSIS
Uniaxial tests performed on core from instrumented sites at Amandelbult 1 shaft, Impala 10 shaft and Union Section Spud shaft showed a nonlinear elastic relationship between applied load and induced deformation. This nonlinear behaviour does not appear to be dependent on borehole orientation but in the case of the Amandelbult and Union sites appears to have been influenced by the stress condition of the rock mass at the time of drilling. Cores drilled at these two sites under destressed conditions, such as over a stope, showed a linear elastic response to the applied load whereas most of the cores drilled under relatively high radial stresses were nonlinear. The Impala 10 shaft tests, however, all showed strong nonlinear behaviour irrespective of the stress condition of the rock mass at the time of drilling, although high stress conditions may have influenced the severity of the nonlinearity. A comparison between underground stress change measurements and an elastic model indicated that the rock mass became nonlinear when the virgin stress condition was relaxed to about 10 MPa. The cores for laboratory testing were retrieved from vertical boreholes drilled up from the centre of a stope and from horizontal boreholes drilled over pillars and stopes at about 600 m, 1 100 m and 1 400 m below surface for the three sites respectively. The k-ratios under virgin conditions were estimated from sockets, modelling and stress measurements to be 1.0, 1.3, and 0.5 for the Amandelbult, Impala and Union sites respectively. Of the three sites, therefore, Impala 10 shaft appears to have had the highest virgin stress state. Tests performed on similar rocks from shallower depths at Impala Platinum essentially showed a linear relationship between stress and strain. From the small Impala Platinum rock test database available to the project, it appears that the nonlinear elastic behaviour initiates at this mine from about 1 000 m below surface and seems to become progressively more nonlinear below this depth. In addition, the nonlinear elastic rocks are weaker, have a lower Young's modulus and a higher Poisson's ratio than their linear elastic equivalents. Interestingly the tangential Poisson's ratios of the nonlinear elastic materials are often greater than 0.5 at 50% of the failure stress, suggesting an early failure initiation. The paper describes the microscope and modelling work done to determine the causes of the nonlinear behaviour and discusses some implications of the behaviour for deep-level mining.
“Full text available only in PDF format”
References
BARR, S.P. and HUNT, D.P. Anelastic strain recovery and the Kaiser effect retention span in the Carnmenellis Granite, U.K. Rock Mech. Rock Engng, vol. 32, no. 3, 1999. pp. 169-193. [ Links ]
BRISTOW, J.R. Micro-cracks and the static and dynamic elastic constants of annealed and heavily cold-worked metals. British J. Appl. J. Phys., vol. 11, 1960. pp. 81-85. [ Links ]
COMRO. MINSIM-D User's Manual, Chamber of Mines of South Africa, Johannesburg. 1981. [ Links ]
GOODMAN, R.E., TAYLOR, R.L., and BREKKE, T.L. A model for the mechanics of joint rock. Journal of the Soil Mechanics and Foundations Division, ASCE. 1968. [ Links ]
HAWKEI, I., MELLOR, M., and GARIEPY, S. Deformation of rock under uniaxial tension. Int. J. Rock Mech. Min. Sc and Geomech Abstr. vol. 10, 1975. pp. 493-509. [ Links ]
HOLT, R.M., BRIGNOLI, M., and KENTER, C.J. Core quality: quantification of coreinduced rock alteration, Int. J. Rock Mech. Min. Sc., vol. 37, 2000. pp. 889-907. [ Links ]
ITASCA CONSULTING GROUP, INC. Fast Lagrangian Analysis of Continua (FLAC), Vers. 3.2. Minneapolis Minnesota USA. 1993. [ Links ]
KACHANOV, M. Effective elastic properties of cracked solids:critical review of some basic concepts, Appl. Mech. Rev., vol. 45, 1992. pp. 304-335. [ Links ]
KAGA, N., MATSUKI, K., and SAKAGUCHI, K. The in situ stress states associated with core discing estimated by analysis of principal tensile stress. Int. J. Rock Mech. Min. Sc. vol. 40, 2003. pp. 653-665. [ Links ]
LIN, W., KWASNIEWSKI, M. IMAMURA, T., and MATSUKI, K. Determination of threedimensional in situ stresses from anelastic strain recovery measurement of cores at great depth, Tectonophysics, vol. 426, 2006. pp. 221-238. [ Links ]
MATSUKI, K. Three-dimensional in situ stress measurement with anelastic strain recovery of a rock core, 7th Int. Congress on Rock Mechanics, Aachen, 1991. pp. 557-560. [ Links ]
RYDER, J.A. and JAGER, A.J. Text book on Rock Mechanics in tabular hard rock mines. SIMRAC, Johannesburg, 2002. p. 278. [ Links ]
SAKAGUCHI, K. IINO, W., and MATSUKI, K. Damage in a rock core caused by induced tensile stresses and its relation to differential strain curve analysis, Int. J. Rock Mech. Min. Sc., vol. 39, 2002. pp. 367-380. [ Links ]
TEUFEL, L.W. Determination of in situ stress from anelastic strain recovery measurements of oriented cores, SPE/DOE 11649, Denver, U.S.A, 1983. pp. 421-430. [ Links ]
TEUFEL, L.W. A mechanism for anaelastic strain recovery of cores from deep boreholes: time-dependent micro cracking, Eos, Trans. Am. Geophys. Union, vol. 70, 1989. pp. 476. [ Links ]
WALSH, J.B. The effect of cracks on the uniaxial elastic compression of rocks, J. Geophys. Res., vol. 70, 1965. pp. 399-411. [ Links ]
WANG, D.F. DAVIES, P.J. , YASSIR, N., and ENEVER, J. Laboratory investigations of controls of stresss history on ASR response, Rock Stress, Balkema, Rotterdam, 1997. pp. 181-186. [ Links ]
WOLTER, K.E. and BERCKHEMER, H. Time dependent strain recovery of cores from the KTB deep drill hole, Rock Mech. and Rock Engng, vol. 22, 1989. pp. 273-287. [ Links ]